Regards Peter Original Message From: Automatic Copy and paste! Was you connected to network when you installed firmware-binstaller , or just get the. English Edit question Status: You received this question notification because you are a direct subscriber of the question.
||20 February 2015
||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
||Free* [*Free Regsitration Required]
In order to gather essential troubleshooting information about your wireless card, please follow this procedure:.
So you first need to install Ubuntu to the harddisk before you can install the firmware, reboot and retest wireless No such file or directory” error message. I have a Broadcom BCM wireless network card and it failed to come up. Can you give the output of: Your answer makes sense to me but do you know where to get the firmware?
Network is down auto lo iface lo inet loopback ubuntu ubuntu: Highlight the command written on the page. This linu has been asked before and already has an answer.
Broadcom 43xx wireless devices
The boradcom kernel module is automatically loaded for supported devices. I would perhaps re install your drivers which should not take long Do this via a terminal and you should see if anything goes wrong. Does this make any difference to your advice?
bcm43xx – Debian Wiki
If you are still being prompted for entering your password make sure that you have enabled your linx to remember the password. You received this question notification because you are a direct subscriber of the question.
Everything worked fine after I’ve installed bfwcutter and firmware-b43legacy-installer. Firmware is not packaged by the Debian Project.
Broadcom BCMMPSG – WikiDevi
Thanks — To answer this request for more information, you can either reply to this email or enter your reply at the following page: Done Reading package lists Installing Broadcom Wireless Drivers 47 answers. The relevant driver has built-in logic to probe the actual chip, for example: I had this same problem on a Dell Latitude D If you still need help, you can reply to this email or go to the following page to enter your feedback: Please proceed with running the following Terminal commands: Configure your wireless broacom as appropriate.
It said no drivers installed. Regards, Mark — To answer this request for more information, you can either reply to this email or enter your reply at the following page: If those answers do not fully address your question, please ask a new question.
The system listed it as “device not ready missing firmware “.
Editing one file bcm4306mpsg rebooting solved the issue. Broadcom Corporation BCM Unable to locate package hwinfo Hardware Lister lshw – B. Just add ” contrib non-free” to the end of your existing line.